The FTEC1 GEN2 Blaster Hardware Kit is out now!
Posted by Tetsu Y on
The FTEC1 Gen2 Hardware kit is finally available! The digital files to print out the blaster are now included with the order of the hardware kit. Get yours now!
Here's what's new with the Gen2:
Improved Durablility:
- The all new airbrake system on the plunger in addition to the silicone buffer pad makes this blaster completely dryfire safe.
- The new catch plate is made of hardened stainless steel and rides on hardened stainless shafts for a reliable catch system that is built to last.
- The catch block now has bearings that prevent it from rubbing witht he inside of the shell.
- TPU buffer prevents priming mechanism from overstroking and hitting the front of the shell.
- TPU spring pad prevents wear on spring spacer stack and catch block faces.
- Higher quality screws are used and all screws required for regular blaster maintenance use heat set brass inserts.
Easier Maintenance:
- Greatly reduced the number of screws required to disassemble blaster for maintenance.
- Features an interlocking pin system for most of the internals instead of screws.
Improved Ergonomics:
- The auto-deploying butt stock is thinner and features multiple indexing points for adjustable length.
- Features vastly improved grip ergonomics and an ambidextrous thumb mag release.
- Added quick disconnect sling points.
Greater Compatibility:
- Adjustable FPS using an integrated spring spacer system.
- Compatible with a wider range of springs.
- Compatible with Talon, Curved Talon, Tachi, and Kodachi magazines.
- Compatible with 5/8" and 16mm barrels.